Waterproofing, protection & concrete repair

The versatility and effectiveness of the PENETRON system have been demonstrated in a wide range of significant projects including: nuclear reactors, the storage of chemicals and tunnel projects for community transportation systems projects. The products adhere to the highest standards of ecological and environmental standards.

The PENETRON crystalline waterproofing cementitious products consist of ordinary cement, quartz sand (of special quality) and various chemical activators that ensure you have the most effective and currently available system for permanent waterproofing of concrete. PENETRON seals and re-seals continuously. Once applied, the PENETRON effect is permanent and supported by our ISO 9002 quality standard warranty. The plant, which manufactures PENETRON, uses advanced technologies and the most demanding quality control processes, which allowed it to obtain the ISO 9001-2000 certification.


  • Becomes an integral part of the concrete. PENETRON ® should not be confused with a coating or membrane
  • Deeply penetrates and seals the capillaries and the shrinkage of concrete cracks
  • Can be applied both on positive and negative surfaces
  • Its waterproofing and chemical resistance properties remain intact even if the surface is damaged
  • It is easy-to-apply, has low installation cost
  • Will not separate at joints, is tear resistant and cannot be perforated
  • Can be applied onto wet or fresh concrete
  • Protects any embedded steel
  • Non-toxic
  • Approved for contact with drinking water





PENETRON can be applied both on positive and negative surfaces in various forms. The chemical reaction begins as soon as PENETRON is applied onto the concrete. PENETRON crystals are scattered through the concrete substrate, increasing its resistance to compression and continuing to protect the concrete from water infiltration or chemicals on a permanent basis. It penetrates up to 1 meter deep and bonds with the concrete. The deep PENETRON effect completely protects concrete structures.


PENETRON® should be applied to concrete or structural blocks exposed to potential infiltration of water or chemical products and that require waterproofing and protection at all times. Its ability to be applied both onto the positive surface (side exposed to water) and the negative surface (side not exposed to water) meets all waterproofing needs. Here are a few examples:

  • Potable water tanks
  • Sewer and water treatment tanks
  • Aquariums
  • Tunnels
  • Elevator shafts
  • Underground vaults
  • Industrial facilities
  • Storey parking
  • Traffic structures
  • Foundation slabs
  • Moulded partitions
  • Fondations
  • Concrete roofs
  • Bathrooms